
Setting up the Scanner
20
2
G
GG
G
Connect the IEEE1394 interface board to the extension connector. Fix the
board with four accessory screws from inside, two accessory screws from
outside.
H
HH
H
Check that it is connected tightly, check that there are no foreign objects
such as metal on the scanner control unit.
I
II
I
Close the scanner control unit cover and fix with seven screws, then insert
the scanner control unit into the main unit.
Note
❒ Be sure to place the scanner on the level surface when inserting the scanner
control unit.
❒ Insert the scanner control unit till you see the screw holes.
J
JJ
J
Fix the scanner control unit with three screws.
K
KK
K
Removed cables must connect in former state.
ADC014S
Comentarios a estos manuales