
Configuring Settings Using a Web Browser
87
3
Example Procedures Using
[
Configuration
]
Main Menu
This section gives you a few example
procedures, to make settings of this
machine using the Web Status Moni-
tor.
Configuring [Scan Settings]
A
AA
A
Click [Configuration] on the main
menu.
The password input dialog box
appears.
Note
❒ Once you set the password, the
password input dialog box will
not appear from the second
time. When the dialog doesn’t
appear, proceed to
D
.
B
BB
B
Enter “scanner” for the user name,
and enter the password.
Note
❒ The user name is fixed to “scan-
ner.”
❒ The password is set to “pass-
word” as the factory default.
You can change the password
using [Configuration] → [Basic
Settings] → [Password].
C
CC
C
Click [OK].
The setup screen appears.
D
DD
D
Click [Basic Settings], and then
[Scan Settings] in the sub-menu ar-
ea.
E
EE
E
Click [Default] in the [Select User]
area.
F
FF
F
Make settings to each of the setup
items on the screen.
Note
❒
Register the scanning conditions
for a scanner you use that are
most frequently used in [De-
fault]. If scanning conditions are
not specified for a Send Scan op-
eration, the conditions set to
[Default] applies.
G
GG
G
Click [OK].
Note
❒ Be sure to click [OK] to save the
settings you have made on the
currently displayed screen.
Once you move to another page
without clicking [OK], all the
settings that you have made on
the previous page will be
cleared.
❒ The changes will be discarded if
you click [Cancel].
H
HH
H
By selecting [User 1], [User 2], or
[User 3] in the [Select User] area, re-
peat the steps
F
FF
F
and
G
GG
G
for each of
them, as necessary.
Configuring [E-mail Address]
A
AA
A
Click [Configuration] on the main
menu.
The password input dialog box ap-
pears.
Note
❒ Once you set the password, the
password input dialog box will
not appear from the second
time. When the dialog doesn’t
appear, proceed to
D
B
BB
B
Enter “scanner” for the user name,
and enter a password.
Comentarios a estos manuales