
Updating Firmware
Firmware for devices managed by
Remote Communication Gate S can be updated, and updates can be
scheduled automatically and remotely. The most recent version as well as previous versions of firmware
are available to download from a global server. Downloaded firmware can be managed by Firmware
Management.
To set a firmware update, follow steps 2 through 5 for each firmware to update.
1. Make service settings (Windows Server 2003 or later)
2. Make initial settings
3. Select a firmware version
4. Set a firmware update schedule
5. Schedule the firmware update
6. Check firmware update results via a URL or the Task List screen.
• During firmware updates, the devices being updated cannot be operated. Therefore, it is
recommended that firmware update be performed at night.
•
During firmware updates, all devices being updated are restarted.
• These batch configurations of firmware are intended only for the devices that are supported.
• Depending on the device model, this feature might not be available.
Service Settings (Windows Server 2003 or Later)
If Remote
Communication Gate S is installed under Windows Server 2003 or newer versions of Windows
Server, you must perform the following procedures to obtain the firmware updates remotely:
1. On the [Start] menu, click [Control Panel], and then select [Services] from [Administrative
Tools].
2. Open the "DH ManagementCore" service properties.
3. In the properties dialog box, click the [Log On] tab, and then select [This account].
4. Enter the account and password of an administrator of the operating system, and then click
[OK].
5. In the [Services] dialog box, start the "DH ManagementCore" service.
• If the administrator's account or password for the operating system was changed during operation,
you must register the new account or password using the procedure above.
6. Firmware Management
234
Comentarios a estos manuales