Ricoh Aficio MP 161F Guia de preparacion Pagina 79

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 122
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 78
Remote Maintenance by telnet
71
2
keyphrase [
phrase
” ]
val [1|2|3|4]
You can specify
the WEP key when
entering in ASCII.
With a 64-bit WEP,
you can use10 digit
hexadecimals. With
a 128-bit WEP, you
can use 26 digit
hexadecimals.
Up to four WEP
keys can be regis-
tered. Specify the
number to be reg-
istered with “val”.
When a WEP is
specified by key
phrase, the WEP
specified by key is
overwritten.
To use this func-
tion, set the same
key number and
WEP key for all
ports that transmit
data to each other.
You can omit the
numbers with
“val”. The key
number is set to 1
when making
these omissions.
The default is
blank.
encval [1|2|3|4] You can specify
which of the four
WEP keys is used
for packet encod-
ing. “1” is set if a
number is not
specified.
wepauth
[open|shared]
You can set an au-
thorization mode
when using WEP.
The specified value
and authorized
mode are as follows:
open: open system
authorized (de-
fault)
shared: shared key
authorized rate
Parameter Value configured
rate [au-
to|11m|5.5m|2m
|1m]
You can set the
IEEE 802.11b trans-
mitting speed.
The speed you
specify here is the
speed at which
data is sent. You
can receive data at
any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
security
{none|wep|wpa}
You can specify
the security mode.
none: No encryp-
tion(default)S
wep: WEP encryp-
tion
wpa: WPA encryp-
tion
wpaenc {tkip|ccmp}
You can specify
WPA encryption
key when using
WPA encryption.
tkip: TKIP (default)
ccmp: CCMP
(AES)
wpaauth
{wpapsk|wpa}
You can specify
the WPA authenti-
cation mode when
using WPA en-
cryption.
wpapsk: WPA-
PSK authentica-
tion(default)
wpa: WPA(802.1X)
authentication
psk "character
string"
You can specify
the Pre-Shared
key.
Usable characters:
ASCII 0x20-0x7e (8
to 63 bytes).
The default is
blank.
Parameter Value configured
Vista de pagina 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 121 122

Comentarios a estos manuales

Sin comentarios