Ricoh Aficio MP 161F Guia de preparacion descargar pdf (Pagina 60)

Monitoring and Configuring the Printer

52

2

authfree

Use the “msh> set bonjour” com-

mand to display and configure au-

thentication exclusion control

settings.

❖ View Settings

msh> authfree

If print job authentication exclu-

sion is not set, authentication ex-

clusion control cannot be

displayed.

❖ IPv4 address settings

msh> authfree "ID" range_

addr1 range_addr2

❖ IPv6 address settings

msh> authfree "ID" range6_

addr1 range6_addr2

❖ IPv6 address mask settings

msh> authfree "ID" mask6_

addr1 masklen

❖ Parallel/USB settings

msh> authfree [parallel|

usb] [on|off]

To enable authfree, set to "on". To

disable authfree, set to "off".

Always specify the interface.

❖ Authentication exclusion control ini-

tialization

msh> authfree flush

Note

❒ For IPv4 and IPv6, up to five access

ranges can be registered and se-

lected.

autonet

Use the “autonet” command to con-

figure AutoNet parameters.

❖ View settings

The following command displays

the current AutoNet settings:

msh> autonet

❖ Configuration

You can configure AutoNet set-

tings.

msh> autonet {on|off}

• {on} means "active" and {off}

means "inactive".

❖ Current interface priority configura-

tion display

msh> autonet priority

❖ Interface priority configuration

msh> autonet priority

“interface_name”

• You can give interface's Au-

toNet parameter priority.

• Priority settings are available

when multiple interfaces are in-

stalled.

• wlan can be specified only

when the IEEE 802.11b interface

is installed.

Note

❒ If an interface is not selected, the

current interface connection set-

tings remain in effect.

❒ For details about AutoNet, refer to

autonet parameters.

Interface name

Interface configured

ether Ethernet interface

wlan IEEE 802.11b inter-

face

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 121 122

Comentarios a estos manuales

Sin comentarios