Ricoh Aficio MP 161F Guia de preparacion descargar pdf (Pagina 74)

Monitoring and Configuring the Printer

66

2

❖ Protocol configuration

msh> snmp {ipv4|ipv6|ipx}

{on|off}

• Use the following command to

set protocols "active" or "inac-

tive": If you set a protocol "inac-

tive", all access settings for that

protocol are disabled.

• Specify "ipv4" for IPv4, "ipv6"

for IPv6, or "ipx" for IPX/SPX.

• {on} means "active" and {off}

means "inactive".

• All protocols cannot be turned

off concurrently.

❖ Configuration of protocol for each

registration number

msh> snmp “number” active

{ipv4|ipv6|ipx} {on|off}

• To change the protocol of access

settings, use the following com-

mand. However, if you have

disabled a protocol with the

above command, activating it

here has no effect.

❖ Access configuration

msh> snmp “number”

{ipv4|ipv6|ipx} “address”

• You can configure a host ad-

dress according to the protocol

used.

• The network interface board ac-

cepts requests only from hosts

that have IPv4, IPv6, and IPX

addresses with access types of

"read-only" or "read-write". En-

ter “0” to have network inter-

face board accept requests from

any host without requiring a

specific type of access.

• Enter a host address to deliver

"trap" access type information

to.

• To specify IPv4 or IPv6, enter

"ipv4" or "ipv6" followed by a

space, and then the IPv4 or IPv6

address.

• To specify IPX/SPX, enter "ipx"

followed by a space, the IPX ad-

dress followed by a decimal,

and then the MAC address of

the network interface board.

❖ sysLocation configuration

msh> snmp location

❖ Deleting sysLocation

msh> snmp clear location

❖ sysContact setting

msh> snmp contact

❖ Deleting sysContact

msh> snmp clear contact

❖ SNMP v1v2 function configuration

msh> snmp v1v2 {on|off}

• Specify "on" to enable, and "off"

to disable.

❖ SNMP v3 function configuration

msh> snmp v3 {on|off}

• Specify "on" to enable, and "off"

to disable.

❖ SNMP TRAP configuration

msh> snmp trap {v1|v2|v3}

{on|off}

• Specify "on" to enable, and "off"

to disable.

❖ Remote Configuration Authorization

configuration

msh> snmp remote {on|off}

• Specify "on" to enable, and "off"

to disable the SNMP v1v2 set-

ting.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 121 122

Comentarios a estos manuales

Sin comentarios