Ricoh AP400 Instrucciones de operaciones Pagina 80

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 212
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 79
Troubleshooting
74
5
Close Duplex
Unit Cover
The cover of the optional Du-
plex Unit is open.
Close the cover of the optional
Duplex Unit.
Close
Front Cover
The front cover is open. Close the front cover.
Close Rear/Paper
Exit Cover
The paper exit cover or the
rear cover is open.
Close the paper exit cover or
the rear cover.
Collate Cancelled The Collate feature has been
cancelled.
Increase the RAM Capacity.
DHCP assigned Cannot
change
The following address have
already been assigned by DH-
CP: IP Address, Gateway Ad-
dress, Subnet Mask.
Disable the default DHCP set-
ting in Network in order to en-
ter the addresses manually.
Driver Setting Error (Memo-
ry)
The printer identified a down-
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.
Verify that the proper memo-
ry size is specified via the
driver setting.
Duplex Cancelled Duplex printing specifications
canceled due to insufficient
memory or selection of a pa-
per size not compatible with
duplex printing.
Install additional memory
units or reduce the amount of
data sent.
Energy Save Mode The printer is in Energy Saver
mode.
Wait for a while.
Error: Enter 10 or 26 Charac-
ters
WEP Key setting error, the
number of alphanumerical
numbers should be either 10
or 26.
Enter the correct value.
Exceeded Max. Pages (Col-
late)
The printer identified a colla-
tion table overflow error.
Install additional memory
units or reduce the amount of
data sent.
Exceeded Max. Stored Pages The maximum number of
pages has been exceeded dur-
ing Sample Print or Locked
Print.
Reduce the number of pages
to print.
Exceeded Max. Stored Files The maximum number of
stored files has been exceeded
during Sample Print or
Locked Print.
Delete the stored files.
Hardware Problem
DIMM
An error has occurred in the
printer.
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Messages/Second messages Description Solution
Vista de pagina 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 211 212

Comentarios a estos manuales

Sin comentarios