Ricoh AP505 Instrucciones de operaciones descargar pdf (Pagina 32)

Operating Instructions

Is the Data In indicator

blinking after starting

the print job?

If not, the data is not being sent to the

printer. The printer maybe resetting the print

job because there was a long delay in receiv-

ing the data from the computer.

• If the printer is connected to the computer

using the interface cable, confirm that the

parallel port setting is set to on.

• If the printer is using the I/O timeout setting,

increase the value of the I/O timeout setting.

If the Data In indicator is blinking, follow

these steps to correct the situation:

• Wait until the printer finishes receiving data

from the computer.

• Cancel the job if the data sent from the

computer is too large or complex.

Can you print a test

page?

If you cannot print a test page, it probably

indicates a printer malfunction. You should

contact your sales or service representative.

If you can print a test page but cannot get the

printer to print when you issue a print com-

mand from your computer, it probably

means there is a problem with your com-

puter. If you cannot solve the problem by

taking the above actions, contact your sales

or service representative.

Possible Cause Solution

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Sin comentarios

Ricoh AP505 Instrucciones de operaciones Pagina 32